Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Press the MODE button to turn a pre-set program(s) ON or OFF. When the
MODE 1 LED is on, all programmed channels for MODE 1 will be activated.
When the MODE 2 LED is on, all programmed channels for MODE 2 will be
activated. To activate both MODE 1 and MODE 2 programs, press the MODE
button until both LED's are on. To turn off all programmed channels, press the
MODE button until both LED's are off.
Range ...........................................................................Up to 100 feet (30.5 m)
Rated Voltage ....................................................................................... 12 VDC
Battery Backup ....................................................9 VDC (Battery not included)
SYMPTOM
Controller does
not come on.
C o n t r o l l e r
does not retain
settings in a
power failure.
Controller will
not operate
receiver.
Please call 1-800-858-8501 (English speaking only) for assistance
If you experience a problem, follow this guide. You may also want to visit our
Web site at: www.hzsupport.com. If the problem persists, call* for assistance
at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
HeathCo LLC, P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service
* If contacting Technical Service, please have the following information available:
Model Number, Date of Purchase, and Place of Purchase.
No Service Parts available for these Products
Specifications
Troubleshooting Guide
POSSIBLE CaUSE
1. Circuit breaker or fuse is
turned off. Power supply
not plugged in.
2. Switch on device is turned
off. Power supply is defec-
tive.
1. Backup battery is not in-
stalled.
2. Backup battery is defective.
1. Dip switch settings on re-
ceiver do not match control-
ler.
2. Wrong group is selected.
3. Signals from controller are
being blocked, or transmit-
ter is out of range.
Technical Service
before returning product to store.
SOLUTION
1. Turn circuit breaker or fuse
on. Plug in power supply.
2. Turned switch on. Try an-
other power supply.
1. Install 9V battery.
2. Replace defective 9V bat-
tery.
1. Check dip switch settings
on receiver.
2. Verify correct group is se-
lected.
3. Check for metal objects that
could block the signal, or
reposition the transmitter.
6
598-1136-04
Tabla de contenido
