Emergency Stopping; Operation; At The End Of A Cleaning Session - Nilfisk T75 Manual De Instrucciones

T75

Emergency stopping

Turn t e switc to 0 to turn o t e mac ine.

Operation

Vacuum au e reen one 3 , red one
en usin t e mac ine, c eck t e ow control
when the machine is operating, the pointer of the vacuum
gauge must remain in the green zone (3) to ensure that
t e speed o t e intake air does not drop elow t e sa ety
value of 20 m/sec;
If the pointer is in the red zone (2) it means that the speed
of the air in the vacuum hose is less than 20 m/s, and that
t e mac ine is not operatin in optimal conditions. S ake
or replace t e filter.
during normal operation conditions, close the vacuum
hose, the pointer of the vacuum gauge must switch from
the green zone (3) to the red zone (2).
When the machine is operating, always check that the
vacuum gauge pointer remains in the green zone (3).
Consult the "Troubleshooting" chapter if faults occur.
I
GB
The air speed in the vacuum hose must not be less than
20 m/s.
Condition indicated by the vacuum gauge pointer in the
green zone (3).
E
E
All machines can be used only with hoses whose
diameters comply with the specifications in the
"Technical Data" table.
Consult the "Troubleshooting" chapter if faults occur.

At the end of a cleaning session

Turn o t e mac ine and remove t e plu
ind up t e connection ca le.
Empty the container and clean the machine as described
in t e Maintenance, cleanin
C360
Phase sequence
Start
Stop
Figure 6
CAUTION!
CAUTION!
CAUTION!
CAUTION!
rom t e socket.
and decontamination
paragraph.
as t e container wit
substances have been vacuumed.
Store the machine in a dry place, out of reach of
unauthorised people.
ock t e castor rakes.
During transport and when not using the machine, close
the vacuum inlet with the relevant plug (if equipped).
10
clean water i a ressive