Geba Tronic Cody Light HF Manual De Instrucciones página 12

Keypad
Creating a new pass code
Cody Light HF Door-opener (up to 4 pass code for the relay output)
The four possible pass codes are programmed in the easiest way.
There are four DIP switches on the logic unit (see picture below). These four DIP switches correspond
to the four memory slots for each pass code.
Put DIP of the
desired memoy
Enter 4 or 5
slot to ON
digit pass code
Set all DIP to
OFF
The new pass code is now saved!
Deleting a pass code
Put DIP of the
push
desired memoy
slot to ON
button
Set all DIP to
OFF
The selected memory slot of the pass code
is now deleted!
push
sound signal
1x long
button
push
sound signal
1x long
button
Keypad
Entering a pass code
Enter 4 or 5
push
digit pass code
button
A correct code is detected; the corresponding relay is switched!
Before the actual pass code, you can press any other keys to prevent fraud.
If an incorrect pass code is entered, you will hear a sound signal (3 beeps).
Entering a new pass code is only possible after the lock-out period (factory: 20 sec.) which end is
signalled by a long sound signal.
sound signal
1x long