Technical Specifications; Electrical Diagrams - Medoc ST 230 Manual De Instrucciones

10.1. Problem: The band saw does not start.
a. Damaged plug.
b. Incorrect voltage.
c. Other cases.
10.2. Problem: A slow engine start or overheat.
Incorrect voltage.
10.3. Problem: Product does not cut well enough. Tail on uncut product.
Unsharpened blade
10.4 Problem: The blade spins in the opposite direction.
Defective connection
11 LIABILITY
No liability will be accepted when the damages caused by inadequate use, defective handling,
structural modifications, removal of the protection devices or use of spare parts which are not
from the manufacturer. The seller will not be liable to the buyer when the damages are caused
to a natural wear out of the machine.
A wrong use of the machine, as well as to use it to cut not food products, increases the risk for
the operator. The seller will not be responsible in case of a bad use of the bandsaw.
12 MACHINE GENERAL DIMENSIONS: See page 3

13 TECHNICAL SPECIFICATIONS

Motor: II 1HP, 1'5HP, 2HP, 230V., 50Hz.
Motor : III 1HP, 1'5HP, 2HP, 3HP, 230/400V., 50Hz.
WARNING: These specifications could change for some countries due to special voltages. Verify the rating
plate of the machine before plugging it
Safety devices at "CE" models: Blade stop before 4 seconds. Buttons and safety devices on low tension.
Interlocking door system. On/off switch, non-voltage release.
Finish......................: Stainless steel and anodised aluminium.
Pulley diameter, mm.
Blade length, mm.
Net weight, Kg.
NOTE: The specifications could be changed without prior notice.

14 ELECTRICAL DIAGRAMS

See page 22 and 23.
15 TECHNICAL SERVICE: VOLTAGE CHANGING
In order to change from 400V to 230V, or from 230V to
400V, follow
the next two operations.
Open the cover of the low tension box (21) (see wiring
diagram):
1.- Connector nº1: Change depending
voltage.
2.- Connector nº2: Change depending
on the desired voltage.
ATTENTION: Both connections must be made on
the same voltage.
 Check the plug cables.
 Verify the plug voltage with the machine voltage.
 Call the distributor authorised.
 Verify the plug voltage with the machine voltage. See ch. 12 .
 Change the blade.
 See chapter 16.
on the desired
ST 230 ST 270
220 250
1.740 1.985
73 85
21
ST 320
300
2.340
97
230 400
0 0 24
1
2