Presentation And General Aspects; General Points; Transportation And Packing; Identification Label - JMA DAKAR Manual De Instrucciones

1
Presentation
and general aspects

General points

1.1
The DAKAR key cutting machine has been designed
taking into account the safety standards in force in
the EU.
The safety of personnel involved in handling this type
of machine is only achieved with a well designed
personnel safety programme, the implementation of a
maintenance programme and following the recommen-
dations given, as well as by complying with the safety
regulations covered in this manual.
Although the installation of the machine presents no
problems, it is best not to try and install, adjust or
operate the machine without having read this manual
first.
1.2

Transportation and packing

The machine comes inside packaging with the
following measurements:
Width = 520 mm, length = 575 mm, height = 650 mm
and 30 kg weight.
Once the machine has been unpacked, carefully
inspect it to ensure that it has not been damaged
during transportation. If any problem is found, inform
carrier immediately and do not do anything with the
machine until the carrier's agent has carried out the
corresponding inspection.
1.3

Identification label

The DAKAR key cutting machine has an identification
label giving the serial number, name and address of the
manufacturer, CE mark and year of manufacture.
See figure 1
2
Characteristics
of the machine
The DAKAR key cutting machine is a high precision,
robust machine. It is characterised by the clamp which has
multiple different possibilities for securing keys without
pads or adapters.
2.1

Families of keys

The DAKAR machine cuts the following types of keys:
Security keys.
Waves keys.
Tubular keys.
FIC-2 and FIC-3 keys.
WIN-1D, WIN-2D, WIN-3D and WIN-4D keys.
JIS-4.P keys.
FO-6.P keys.

Main elements of the machine

2.2
1
Clamp-holder slide, x – y axes
2
Head, z axis
3 Tracer point side tilting clamp
4 Milling cutter side tilting clamp
5
Clamp knob
6 Clamp-holder slide locking knob, x axis
7 Slide springing system drive wheel, x axis
Tracer point locking handle
8
9 Z axis head drive and locking lever
Slide drive lever, x – y axis
10
Bit-holder, tracer point and milling cutter
11
Tracer point
12
Milling cutter
13
General switch
14
Motor switch, 2 speeds
15
Light
16
Tool drawer
17
Chip guard
18
Keypad and calibration lights
19
Clamp rotation locking lever
20
Clamp-holder slide locking knob, x – y axes
21
2.3

Technical data

Motor: Single phase 200 W, 230 V – 50 Hz
Milling cutter: super quick-speed steel
Milling speed: 5500 and 8000 rpm
Clamps: With two securing faces and tilting 0 / 45º
Movements: On three axes with ball guides
Tool travel: X axis = 60 mm, Y axis = 60 mm and Z axis = 40 mm
Lighting: 20 watt 12V halogen light
Dimensions: Width = 310 mm, Depth = 380 mm and Height =
420 mm
Weight: 25 Kg
See figure 2
9