Chario SW1 Instrucciones De La Instalación página 5

READ THE FOLLOWING WARNINGS BEFORE USING THIS UNIT
1. Installation This unit is intended to be placed upright on the floor
and is not suitable for in-wall mounting.
2. Ventilation do not place this unit too close to walls or furniture
allowing a clearance of at least 10 cm (5 inch) all around.
3. Heat this unit should be kept away from any heat source to
avoid its temperature increasing.
4. Water to prevent electric shock do not expose this unit to water
or moisture.
5. Power source be sure your wall outlet main voltage matches the marking
on the label.
6. Lightning to prevent damage disconnect this unit from the wall outlet
during storms.
7. Non use disconnect this unit from the wall outlet when left unused
for a long period of time.
8. Power cord power supply cord should be routed to avoid walking on it
or pinching it.
9. Grounding for safety's sake be sure the grounding of this appliance is
not removed.
10. Moving unplug this unit from the wall outlet when moving it and
never pull connecting cables but gently disconnect them.
11. Cleaning unplug this unit from the wall outlet and use only a damp
cloth, never solvents.
REMEMBER: as long as this unit is connected to the wall outlet, it is not
disconnected from the AC power source even if the apparatus itself is turned off.
This unit is magnetically shielded
Never open the cabinet
if anything fails contact your dealer.
Congratulations on Your choice!
This subwoofer unit is certainly one of the best choices available on the
international Hi-Fi market today. Chario offers high electroacoustic
technology which places each of its components at the top of its class for
quality. This means that audiophiles will take the maximum pleasure when
listening to their favourite music through chario loudspeakers. In this booklet
we would like to give you some suggestions about the correct connection
between your amplifier/receiver and the subwoofer unit.
Power source
This electronic device is not provided with a voltage selector.
Each subwoofer unit comes with its proper power supply from the factory and
marked with only one of two labels below:
SW1
230V-50Hz 180 VA
POWER
T 1.25 AL
115V-50Hz 180 VA
POWER
T 2.5 AL
Be sure the figure is the right one requested by AC mains in your country.
If the above condition is not correct please contact your dealer.
Do not try to power this unit!
BEFORE INSTALLATION PROCEDURE
BE SURE BOTH A/V AMPLIFIER/RECEIVER AND THE POWERED SUBWOOFER ARE
TURNED OFF. THEN SET THEIR VOLUME KNOBS TO ZERO POSITION
(FULLY COUNTER-CLOCKWISE)
SW2
230V-50Hz 230 VA
POWER
T 2 AL
or
115V-50Hz 230 VA
POWER T 4 AL