More Functions - DJI AGRAS T20 Guia De Inicio Rapido

Performing an Operation
Take the aircraft to one of
the calibration points.
Tap Invoke, and then
tap Rectify Offset.
Only take off in open areas and set an appropriate auto-takeoff height according to the operating environment.
●
An operation can be paused by moving the control stick slightly. The aircraft will hover and record the breakpoint,
●
and then the aircraft can be controlled manually. To continue the operation, select it again from the Executing tag in
list, and the aircraft will return to the breakpoint automatically and resume the operation. Pay attention to aircraft
safety when returning to a breakpoint.
In Route Operation mode, the aircraft is able to circumvent obstacles, which is disabled by default and can be
●
enabled in the app. If the function is enabled and the aircraft detects obstacles, the aircraft will slow down and
circumvent the obstacles, and then return to the original flight path.
Users can set the action the aircraft will perform after the operation is completed in the app.
●
More Operation Modes
Refer to the Agras T20 User Manual for more information about the A-B Route, Manual, and Manual Plus Operation modes.

More Functions

Operation Resumption
Refer to the Agras T20 User Manual for more information.
6. Maintenance
Clean all parts of the aircraft and remote controller daily and immediately after spraying:
1. Fill the spray tank with clean water or soapy water and spray the water through the nozzles until the tank is empty. Repeat
the step two more times.
2. Detach the spray tank and spray tank connector to clean them. Remove the spray tank strainer, nozzle strainers, and nozzles
to clean them and clear any blockage. Afterwards, immerse them in clean water for 12 hours.
3. Use a water-filled spray washer to clean the aircraft body and wipe it with a soft brush or wet cloth before cleaning water
stains with a dry cloth.
4. If there is dust or pesticide liquid on the motors and propellers, wipe them with a wet cloth before cleaning water stains with a
dry cloth.
5. Wipe the surface and screen of the remote controller with a clean wet cloth that has been wrung out with water daily after
operations.
Refer to the disclaimer and safety guidelines for more information on product maintenance.
10
Tap Execute Operation
in the home screen of the
app.
Tap Start.
System Data Protection
Tap , select the field
from the field list.
Set the operation
parameters, then confirm.
Empty Tank
Tap Edit to edit the waypoints
and flight route again.
Set the auto-takeoff height and
move the slider to take off. The
aircraft will perform the operation
automatically.