Setting The Gap For The Proximity Switch; Exchanging The Brushes; Replacing The Upper Brush; Replacing The Lower Brush - Suevia KRAZZMAXX III Manual De Instrucciones Y Montaje

2.4 Setting the gap for the proximity switch

The gap between proximity switch and counter-magnet should be approx.
20mm.
Figure 6: Proximity switch and counter-magnet

3. Exchanging the brushes

Note: The brushes are to be exchanged at your discretion. Replacement is
indicated, however, when the shortest bristles at less than 5cm long.
Figure 7: Overview of brush replacement
SUEVIA HAIGES GmbH • Max-Eyth-Str. 1 • 74366 Kirchheim am Neckar • Deutschland • Tel. +49 7143 971-0 • Fax +49 7143 971-80

3.1 Replacing the upper brush

Procedure, (see Figure 8):
• Remove the screw (Pos. 1).
• Take off the disc (Pos. 2).
• Pull the brush from the square section (Pos. 3)
Pos. 1
Pos. 2
Pos. 3
Figure 8: Mounting the upper brush

3.2 Replacing the lower brush

Procedure (see Figure 9):
• Remove the screws (Pos. 1) on the left and right.
• Loosen the 2 threaded pins on the flanged bearing.
• Pos. 2 can now be removed together with the lower bearing.
• Remove the locking ring (Pos. 3).
• Pull the brush off the square section (Pos. 4).
Pos. 4
Figure 9: Mounting the lower brush

4. Maintenance

• Check once a month that all screws are tight. Retighten the screws
if necessary.
• Re-grease the slide, if necessary.
• Please use normal everyday cleaning agents.
• Never use solvents, acids or caustic agents for cleaning purposes.
• Gear oil: SAE 90 API GL5
EN 4/6
www.suevia.com • [email protected] • Stand: 30.05.2015
Pos. 3 Pos. 2 Pos. 1