C Hecks And C Onnection To The M Ains E Lectricity S Upply; Operation - BM2 BIEMMEDUE M130 Manual Del Usuario

4.3 C C
heCks anD onneCtIon to the
m
WARNING
• A Skilled Technician must check that the electrical supply complies with the data indicated
on the identification label (7) on the high pressure cleaner. It is especially important that the
supply voltage does not differ more than ±5% from that indicated on the label.
• All connections to mains electricity must be carried out by a Qualified Eletrician according to
IEC 364 regulations or the equivalent standard in the country where the high pressure cleaner
is to be used. It is especially important that the current outlet where the high pressure cleaner is
connected is provided with an earth conductor and a suitable fuse (according to the size indicated
on the identification label and in the table of technical specifications), and must be protected by
a magneto-thermal differential circuit breaker, whose sensitivity is not in excess of 30 mA.
• If the power supply cable is too short, an extension cord can be used provided it is not longer
than 10 m/32.8 ft, the section of the wires is at least 1,5mm² and the plug and the socket are
waterproof. Contact a Qualified Eletrician so that all these requirements are followed.
The use of unsuitable extension cords can be dangerous.
5 o
peratIon
m
WARNING
• The high pressure cleaner must be used with care and attention. It is your responsibility to
make sure that any infrequent users have read these instructions and are acquainted with the
operation of the water cleaner; otherwise do not allow others to use the high pressure cleaner.
Water cleaners must not be used by children or by unauthorised personnel.
• Comply with the safety warnings in the operating and maintenance instructions of any optional
accessories to be used.
• Do not use the high pressure cleaner if:
- the power supply cable or other important parts such as the high pressure pipe, the safety
devices, the cleaner gun and the lance are damaged;
- the high pressure cleaner has been tipped over or has been bumped;
- there are obvious leaks of water.
In these circumstances, the water cleaner should be tested by a Skilled Technician.
• It is especially important to pay great attention when the high pressure cleaner is used in areas
where there are moving vehicles as these can crush or damage the power supply cable, the
high pressure pipe, the cleaner gun etc.
• During operation, never leave the water cleaner unattended and make sure it is out of children's
reach. Pay particular attention when using it in kindergartens, nursing homes and old people's
homes, as unsupervised children, elderly people and disabled people may be present in such places.
• Before using the water cleaner, make sure it is in a dry place and that it is in a flat and stable
position in order to avoid accidents and prevent it from falling over.
• Before moving the water cleaner, follow the instructions in the "Switching off" section.
• Before starting the water cleaner, put on clothing which guarantees adequate protection against
the possibility of incorrect manoeuvres of the jet of pressurised water. Do not operate the water
cleaner near people unless they are also wearing protective clothing.
• High-pressure jets of water can be dangerous if they are not used properly. Do not point the jet
in the direction of people, animals, and energized electrical appliances or towards the water
cleaner itself.
• Hold the cleaner gun firmly during use: when operating the lever (26), the operator is sub-
jected to the backlash of the high pressure. The power of this recoil is indicated in the table
of technical specifications (recoil is expressed in N, where 1 N = 0.1 kg).
30
m e
aIns leCtrICIty
s
upply