Intended Use; Special Safety Instructions - Flex AD 14,4 Instrucciones De Funcionamiento Originales

AD/ADH/AID 14.4

Intended use

The cordless impact driver AID 14.4
is designed
– for commercial use in industry and trade,
– for tightening and loosening nuts and bolts
in the indicated dimensions.
The cordless drill driver AD 14.4 is designed
– for commercial use in industry and trade,
– for screwing in and removing screws,
– for drilling into wood, metal, ceramic
and plastic.
The cordless impact drill and screwdriver
ADH 14.4 is designed
– for commercial use in industry and trade,
– for screwing in and removing screws,
– for drilling into wood, metal, ceramic
and plastic,
– for impact drilling in brick, masonry
and stone.
Safety instructions for drills
and screwdrivers
 If the insertion tool or screw is at risk
of coming into contact with concealed
power cables or the power cord itself,
hold the device by the insulated grip
surfaces.
If the screw makes contact with a live cable,
metal parts of the device may also become
live and cause an electric shock.
 Use suitable detectors to detect con-
cealed power supply cables or consult
your local supply company.
Contact with electric cables may
result in a fire and/or electric shock.
A damaged gas pipe may cause
an explosion. A pierced water pipe
will result in damage to property.
 Immediately switch off the power tool
if the bit locks. Be prepared for high
reaction torque which can cause
kickback.
The insertion tool locks if:
– the electric power tool is overloaded
or
– it becomes wedged in the workpiece.
 Hold the electric power tool securely.
When tightening and loosening screws,
high reaction torques may occur briefly.
 Secure the workpiece.
A workpiece is held more securely in
a clamping device or vice than by hand.
 Wait until the electric power tool has
come to a standstill before putting
it down. The insertion tool may jam and
cause you to lose control of the electric
power tool.
 Do not open the battery.
There is a risk of a short-circuit.
 Protect the battery from heat, e.g. from
continuous exposure to sunlight, fire,
water and humidity.
There is a risk of explosion.
 Use the battery only in conjunction
with the specified electric power tool.
Otherwise, the battery will not be protected
from a dangerous overload.
 Use only original batteries with
the voltage indicated on the rating
plate of your electric power tool.
If other batteries are used, e.g. imitations,
reconditioned batteries or third-party
products, there is a risk of injuries as well
as amage caused by exploding batteries.
Additional safety instructions
for impact drill/driver (ADH 14.4)
 Wear hearing protection when impact
drilling. The effect of noise may result
in loss of hearing.

Special safety instructions

 Before performing any work on the power
tool, set the direction of rotation selector (6)
to the middle position.
 Do not actuate the direction of rotation
selector (6) or torque setting (4) until
the tool is at a standstill.
 The mains voltage must correspond with
the voltage information on the rating plate
of the battery charger.
 Identify the power tool with stickers only.
Do not drill any holes into the housing.
15