Output The Sine Waveform - Beta 1760DGT/2 Manual De Usuario

the up, down, left, right direction keys and "Enter" key to set frequency parameter,
select "OK" and press "Enter" button to confirm.
4. Set offset
Press F4 button to enter the second page. Press F2 to select Offset, then use the up,
down, left and right direction keys to adjust the frequency, press F2 button to open the
digital keyboard again, use the up, down, left, right direction keys and "Enter" key to
set frequency parameter, select "OK" and press "Enter" button to confirm.
5. Set duty cycle
enter the second page. Press F3 to select Duty, then use the up, down, left and right
direction keys to adjust the frequency, press F3 button to open the digital keyboard
again, use the up, down, left, right direction keys and "Enter" key to set frequency
parameter, select "OK" and press "Enter" button to confirm.
6. Generate an arbitrary waveform
It is necessary to edit the arbitrary waveform in connection with the software and
download it into the machine. There are 4 arbitrary wave positions, and each position
can permanently store an arbitrary wave.
7. After setting the waveform parameters, press the
output. The output waveform of the signal generator can be observed through an
oscilloscope.

Output the sine waveform

Output a sine waveform with 10KHz/2.5Vpp as follows:
1. Press AWG button to enter the waveform generator function interface.
2. Press F1 to select "Sine";
3. Frequency: First press F2 button to select Frequency, then use the up, down, left
and right direction keys to adjust the frequency. Second press F2 button to open the
digital keyboard again, use the up, down, left, right direction keys and "Enter" key to
set frequency parameter, select "OK" and press "Enter" button to confirm. Set the
frequency to 10KHz;
4. Amplitude: First press F3 button to select Amplitude, then use the up, down, left and
right direction keys to adjust the amplitude. Second press F3 button to open the
digital keyboard again, use the up, down, left, right direction keys and "Enter" key to
set amplitude parameter, select "OK" and press "Enter" button to confirm. Set the
amplitude to 2.5V;
5. Offset: Press F4 to enter the second page. First press F1 button to select Offset,
then use the up, down, left and right direction keys to adjust the offset. Second press
F1 button to open the digital keyboard again, use the up, down, left, right direction
button to turn on or off the signal
72