Sanus VXF220 Instrucciones De Montaje página 8

2 Mount the Wall Plate
2-1 Locate studs
41 - 61 cm
(16 - 24 in.)
2-2
Mark the wall
2-3
Drill pilot holes
2-4
Tighten lag bolts
[22]
[20]
8
Wood stud
< 16 mm
(5/8 in.)
[01]
[01]
For assistance in determining wall plate location, see Height
Finder at sanus.com.
Verify the center of the stud(s) using an awl, a thin nail, or an
edge to edge stud fi nder.
CAUTION:
Avoid potential personal injuries and property
damage!
Any material covering the wall must not exceed 16 mm
(5/8 in.).
Minimum wood stud size: common 2 x 4 in (nominal 1½ x
3½ in).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 89 mm (3½ in.), using a
5.5 mm (7/32 in.) diameter drill bit.
89 mm
(3½ in.)
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage
DO NOT over-tighten the lag bolts [20].
Tighten the lag bolts [20] only until the washers [22] are
pulled fi rmly against the wall plate [01].
13 mm 5.5mm
(1/2 in.) (7/32 in.)
6901-002080 <03>