Connecting The Water Supply Line - Glacier bay N2316 Guía De Uso Y Cuidado

Ocultar thumbs Ver también para N2316:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Installation (continued)
7
Installing and adjusting the flush
button
Position the flush button mechanism (QQ) in tank lid so the
single drop button will align with blue button (half flush) on
top of the flush valve and double drop button aligns with
the grey button (full flush). This will also align the blue and
grey rods on the flush button to the same color buttons on
top of the flush valve
Secure the flush button mechanism (QQ) in the tank lid by
hand tightening the lock nut (1).
The rubber tip on the bottom of the push rods leading from
the flush buttons should be slightly backed off from the top
of the levers on the flush valve.
To increase the rod length, turn the rod locknut counter-
clockwise to loosen, then rotate the push rod counter-
clockwise to increase exposed length. When the desired
length is achieved, turn the rod locknut clockwise, while
holding the push rod, until it is tightened.
NOTE: Do not overtighten the tank connection.
8

Connecting the water supply line

Connect the water supply line (not included) between the
tank (A) and shut-off valve.
Tighten the tank connection coupling nut ¼ turn beyond
hand tight.
Turn on the supply valve and allow the tank (A) to fill.
Check for leakage at all connections and tighten or correct
as needed.
NOTE: Do not overtighten the tank connection.
7
Please contact 1-855-HD-GLACIER for further assistance.
HOMEDEPOT.COM/GLACIERBAY

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

215583468213100006449810013627981005748381

Tabla de contenido