Delete Character(s) on Output Result
EN
Inateck P7 can help users delete character(s) on output result, either beginning characters
or the ending ones. 0 to 99 digits can be deleted. As default setting, no character, or say 0
digit is deleted as output result. More details are as below.
1. Scan "Enter Setup" Barcode
2. Scan "Delete Beginning Character(s)" Barcode or "Delete Ending Character(s)" Barcode
Delete Beginning Character(s)
3. Scan the digit(s)barcode to be deleted.
(*)0 digit
4. Scan "Exit with Save" Barcode to end the setting
Note: Refer to the setting of "delete 0 digit character" if no character should be deleted.
10
2 digits
4 digits
6 digits
8 digits
Enter Setup
Delete Ending Character(s)
Exit with Save
1 digit
3 digits
5 digits
7 digits
9 digits