Connecting The Printer; Loading Labels - Uline DYMO LABELWRITER 450 Guia De Inicio Rapido

NOTE: For Windows, do not connect the printer
to your computer until instructed to do so
during the software installation.
TO CONNECT THE POWER
1. Plug the power
cord into the
power adapter.
(See Figure 2)
2. Plug the power
adapter into the
power connector
on the bottom
of the printer.
(See Figure 3)
3. Plug the other end
of the power cord
into a power outlet.
The LabelWriter Twin Turbo printer holds two label rolls,
so you can print two types of labels without having to
change the label roll. For example, load address labels
on the left side and return address labels on the right side.
TO LOAD A LABEL ROLL
1. Press the form-feed button to eject the labels that
protected the printer during shipment.
2. Open the top cover and remove any packing
material inside the label compartment.
3. Remove the label spool from inside the cover.
4. Hold the spool
spindle in your left
hand and place
the label roll on
the spindle so that
the labels feed
from underneath
and the left edge
of the label roll is
flush against the
side of the spool. (See Figure 5)
5. Place the spool guide onto the right side of the
spool and press the guide tightly against the side of
the label roll, leaving no gap between the roll and
the spool. (See Figure 6)
PAGE 2 OF 9

CONNECTING THE PRINTER

Power Adapter
Power Cord
Power
USB
Connector
Port
Cable
Channel

LOADING LABELS

Spool Spindle Spool Guide
Figure 5
4. Plug the USB cable
into the USB port on
the bottom of the
printer. (See Figure 3)
5. Insert the power and
USB cables through
the cable channel
and set the printer down. (See Figure 4)
NOTE: DO NOT CONNECT the other end of the
USB cable to your computer until asked to do
Figure 2
so during the software installation.
6. Connect the printer to your computer as follows:
a. For Windows: plug the USB cable into a USB
port ONLY when prompted during the software
installation.
b. For Mac OS X: plug the USB cable into a USB port
Figure 3
prior to installing the software.
NOTE: The label
roll must fit snugly
against both sides of
the label spool, with
no gaps, to avoid
drifting as the labels
feed through the
printer. (See Figure 6)
6. Insert the label spool
into the slot in the
printer cover with the
labels extending from
underneath the roll.
(See Figure 7)
7. Align the left edge of the
label with the left edge
of the label feed slot and
insert the label into the slot. (See Figure 8)
NOTE: The printer
feeds the labels,
stopping at the beginning of the first label. If
the printer does not feed the labels, make sure
the first label is fully inserted and then press the
form feed button.
8. Repeat steps 3 through 7 to load a second roll of
labels (for example, postage labels).
9. Close the top cover.
USB
Port
Figure 4
Figure 6
Figure 7
Figure 8
1121 IH-1266