Cameo CLMPAR3 Manual De Usuario página 15

OPERATION:
DIMMER
In "DIMMER" mode, each of the four individual lights
can be set to an individual static colour through colour
mixing. Press the MODE button repeatedly until "DIMMER"
appears in the display. Then press ENTER and use the UP
and DOWN buttons to select the desired light 1 - 4 and
confirm with ENTER. Now the display shows the bright-
ness values of the individual colour LEDS (R = red, G =
green, B = blue, and W = white) of the selected light from
00 to 99. The cursor is the "R" field in the top line. Now
use the UP and DOWN buttons to set the brightness of the
red LED. Pressing ENTER confirms the input and moves
the cursor ahead to the "G" field for the green colour
LEDs. Here, again use the UP and DOWN buttons to set the
brightness to the desired value. The same procedure also
applies analogously for the blue (b) and white (w) LEDs.
After confirming the value for the white LEDs by pressing
ENTER, "DIMMER" appears in the display again and you
can select one of the four lights for colour adjustment as
described above.
DMX MODE
This menu item makes it possible to select both the DMX
start address and the DMX mode in which the multi-PAR
lighting system should operate.
Press the MODE button repeatedly until "DMX MODE"
appears in the display. Then press ENTER. The cursor
appears in the "ADDR:xxx" field. Use the UP and DOWN
buttons to select the DMX start address of the lighting
system from 001 to 512. Confirm the input with ENTER.
Simultaneously, the cursor jumps ahead to the "CH:xx"
field. There are 7 different DMX modes that can be selec-
ted using the UP and DOWN buttons. Confirm the input
with ENTER. The various DMX modes are explained on one
of the following pages.
15