Getting Started; Set Up Remote Sensor - Oregon Scientific I300 Manual De Uso

Front View:
1. LED status indicator: Blink when transmitting a
reading
Back View:
1. RESET: Reset unit to default settings
2. Channel Switch
3. Battery compartment

GETTING STARTED

SET UP REMOTE SENSOR

1. Slide open the battery door.
2. Select channel.
3. Insert the batteries, matching the polarities (+ / -) and
press RESET.
4. Close the battery door.
NOTE
• Install batteries in the remote sensor before installing
the USB Communications Hub and main unit.
• Press RESET after each battery change.
5. Secure the sensor in the desired location using the
wall mount bracket.
6. Press and hold SEARCH on USB Communications
Hub to initiate search and start receiving data from
the sensor.
NOTE USB Communications Hub will search only for
already registered sensor or new sensor reset within last
30 minutes. To register a new sensor, reset sensor prior
to search.
7. Press and hold
search.
For best results:
• Place the sensor within 100 m (300 ft) of the USB
Communications Hub and main unit.
5
on the main unit to initiate sensor