Wolf Garten LYCOS 40/300 T Instrucciones De Funcionamiento Originales página 28

EN
Note
arm.
Adjusting the middle handle
Release the nut on the middle handle
Push the middle handle to the desired height
between the two adjustment limiters (a).
Adjust the inclination of the middle handle
Align the middle handle on the arm so that the
imprinted arrow on the fastening piece is aligned
with the marking line on the arm and retighten the
nut .
Note
arm.
Attaching the carrying belt
Attach the carrying belt
hooks on the hook of the operating module.
Adjusting the carrying belt
Adjust the carrying belt to the desired length. The
attachment hook should be at hip height
Note
tiring too
Note
Fitting the cutting blade
Rotate the line head until the hole in the spacer is
aligned with the recess of the gear casing.
Push the retaining rod
the hole and hold it tight to lock the thread
Hold the retaining rod tightly and rotate the line
head clockwise (to the right) from the drive
shaft / .
28
.
.
using the two snap
.
through the recess in
.
Push the cutting blade
and position it, centred, on the spacer. Press the
cutting blade tightly home.
Note
Push the retaining dome
and the cutting blade
Rotate nut anticlockwise (left) on the drive
shaft and tighten to a torque of 20 Nm
Note
Note
turn (360°).
Remove the retaining rod
Remove the blade safety cover from the cutting
blade .
Note
Fitting the line head
Remove the blade in the reverse sequence to that
described in the section "Fitting the cutting
blade" .
Lock the gearbox with the retaining rod
rotate the line head anticlockwise (left) on the
drive shaft.
Manually tighten the line head.
Assembly
on to the drive shaft
on to the drive shaft
.
.
.
and
-
-