DeWalt D28710 Traducido De Las Instrucciones Originales página 30

E N G L I S H
outdoors, only use extension cables intended for
outdoor use and marked accordingly.
13 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended. Do not force the tool.
Warning! The use of any accessory or attachment
or performance of any operation with this tool
other than those recommended in this instruction
manual may present a risk of personal injury.
14 Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts,
damage to guards and switches and any other
conditions that may affect its operation. Ensure
that the tool will operate properly and perform
its intended function. Do not use the tool if any
part is damaged or defective. Do not use the tool
if the switch does not turn it on and off. Have
any damaged or defective parts replaced by an
authorised D WALT repair agent. Never attempt
E
any repairs yourself.
15 Unplug tool
Switch off and wait for the tool to come to a
complete standstill before leaving it unattended.
Unplug the tool when not in use, before
changing any parts of the tools, accessories or
attachments and before servicing.
16 Avoid unintentional starting
Do not carry the tool with a fi nger on the switch.
Be sure that the tool is switched off before
plugging in.
17 Do not abuse cord
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
18 Store idle tools
When not in use, tools must be stored in a dry place
and locked up securely, out of reach of children.
19 Maintain tools with care
Keep the tools in good condition and clean
for better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
28
20 Repairs
This tool is in accordance with the relevant
safety regulations. Have your tool repaired by an
authorised D WALT repair agent. Repairs should
E
only be carried out by qualifi ed persons using
original spare parts; otherwise this may result in
considerable danger to the user.
Additional Safety Instructions for Chopsaws
• Always wear regular working gloves while
operating this tool.
• Keep hands away from the cutting disc. Never
cut workpieces that require manual action closer
than 15 cm from the rotating cutting disc.
• Do not cut workpieces less than 1.2 mm in
thickness when using the cutting disc supplied
with this tool.
• Do not operate this tool without guards in place.
• Do not perform any operation freehand. Use the
material clamp to clamp the workpiece securely.
• Never reach in the back of the cutting disc.
• Always position the tool on a fl at, stable
surface that is well maintained and free of loose
materials, e.g. chips and cut-offs.
• Before using, inspect the cutting disc for cracks
or fl aws. Discard the cutting disc if a crack or
fl aw is evident or if it is otherwise defective.
• Make sure the cutting disc is not contacting the
workpiece before the tool is switched on.
• In operation, avoid bouncing the cutting disc or
giving it rough treatment. If this occurs, stop the
tool and inspect the cutting disc.
• Do not operate the tool while standing in line with
the cutting disc. Keep other persons away from
the work area.
• Be aware of cutting chips and the material being
cut. They may be sharp and hot. Allow cut off
parts to cool before handling.
• The spark defl ector becomes hot during use.
Avoid touching or adjusting the spark defl ector
immediately after operation.
• Switch off the tool and wait for the cutting disc to
stop before moving the workpiece or changing
the settings.
• After switching off, never attempt to stop the
cutting disc by pressing against the side of the
disc.