Ryobi ACRM005 Manual Del Usuario página 4

USING THE BAGGING KIT
See Figure 11 - 12.
WARNING:
Added accessories can affect the stability of the mower
when operating on slopes. Use additional care when mow-
ing on slopes with the bagging kit installed. Never attempt
to tow with the bagging kit installed. Failure to follow these
instructions can result in death or serious personal injury.
WARNING:
Be especially careful before and when backing with the bag-
ging kit installed, as it may limit visibility. Always look closely
behind and down for small children, bystanders, and pets
and move the mower slowly to prevent back over accidents
that can cause death or serious personal injury.
 Install bagging kit as previously described.
 Mow as desired, keeping aware of the status of the bag full
indicator. When the ridged wheel stops spinning, the bags
are full and need to be emptied.
NOTE: If the bag full indicator stops spinning when the bags
are not full, check for a clog in the tubes.
Make sure the drive levers are in the neutral position and

the blade engage knob is down.
 Stop the motor, remove the start key, and set the parking
brake.
 Lift the cover and empty the clippings from the bags.
 Replace the bags and close the cover fully.
 Reinstall start key and restart mower when you are ready to
return to mowing.
NOTE: Always empty the bags before storing the mower.
NOTICE:
Properly dispose of grass clippings in accordance with
all laws and local ordinances.
OPERATING TIPS
 Avoid cutting wet grass or grass that is heavy with dew.
Grass that is wet will be sticky and could adhere to bagger
parts.
 If the bagger fails to pick up cut grass or leaves when the
bags are not full, it may indicate that a clog has occurred.
Stop the motor, remove the start key, set the parking brake,
and check all parts of the bagger for clogged material.
 If desired, plastic trash bags can be inserted inside bagger
for ease of debris disposal.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
MAINTENANCE
The bagger assembly is subject to deterioration and wear and
should be checked each time the mower is used. If replacement
is needed, make sure the new bagger meets original manufac-
turer's recommendations and specifications.
P.O. Box 1288
Anderson, SC 29622
1-800-860-4050
www.ryobitools.com
BAG FULL
INDICATOR
Fig. 11
Fig. 12
995000754
12-10-18 (REV:01)