Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their riding lawn mower before
using this accessory. Save these instructions. Refer to them
frequently and use them to instruct other users. If you loan
someone this product, loan them these instructions also.
PACKING LIST
Bagging Blades (2)
Hitch Pin
Bags (2)
Lower Bagger Tube
INSTALLING THE BAGGING KIT
This kit includes a bagger and special mower blades designed
to be used when bagging. Install the blades first, then install
the bagging kit.
REMOVING THE CUTTING DECK
See Figure 1.
If desired, the cutting deck can be removed from the mower to
make accessing the blades easier when changing.
Make sure drive levers are in open position and blade engage
knob is down.
Stop the motor, remove the start key, and set the parking
brake.
Disconnect both cables that connect the cutting deck to the
mower.
Lower the cutting deck to its lowest position.
Remove the 3 hitch pins and washers that secure the cutting
deck in place.
Slide the deck out from under the mower.
Reverse the process to reattach the cutting deck to the
mower.
INSTALLING BAGGING BLADES
See Figures 2 - 3.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal injury
and damage to the mower.
NOTE: Make certain all parts are replaced in the exact order in
which they were removed.
Make sure drive levers are in open position and blade engage
knob is down.
Stop the motor, remove the start key, and set the parking
brake.
ACRM005 BAGGING KIT
FOR USE WITH RYOBI ELECTRIC ZERO TURN MOWER
Bagger Bracket
Bagger Cover
Upper Bagger Tube
CABLE (x2)
CUTTING
DECK
WASHER
WRENCH
BLOCK OF WOOD
Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift or
using a jack and jack stands, or remove the cutting deck
as described in the previous section to gain access to the
blades.
HITCH PIN
Fig. 1
BLADE
Fig. 2
Manuales relacionados para Ryobi ACRM005
Resumen de contenidos para Ryobi ACRM005
- Página 1 ACRM005 BAGGING KIT FOR USE WITH RYOBI ELECTRIC ZERO TURN MOWER WARNING: CABLE (x2) To reduce the risk of injury, user must read and understand the operator’s manual for their riding lawn mower before using this accessory. Save these instructions. Refer to them frequently and use them to instruct other users.
- Página 2 BLADE WARNING: CIRCLE POST If raising the mower to access the blades, make sure the SHAFT BLADE HALF mower is properly secured and the parking brake is set CIRCLE POST before proceeding. Failure to properly secure the mower could cause it to fall, resulting in possible death or serious personal injury.
- Página 3 HOLE FRAME SHAFTS COVER UPPER TUBE COVER OPENINGS Fig. 8 Fig. 5 COVER BAGS LOWER TUBE FRAME LATCH LATCH Fig. 9 Fig. 6 UPPER TUBE LATCH LOWER TUBE Fig. 7 Fig. 10...
- Página 4 USING THE BAGGING KIT BAG FULL See Figure 11 - 12. INDICATOR WARNING: Added accessories can affect the stability of the mower when operating on slopes. Use additional care when mow- ing on slopes with the bagging kit installed. Never attempt to tow with the bagging kit installed.
- Página 5 TROUSSE D’ENSACHAGE ACRM005 À UTILISER AVEC LA TONDEUSE ÉLECTRIQUE À BRAQUAGE ZÉRO RYOBI AVERTISSEMENT : CÂBLE (x2) Pour réduire les risques de blessure, l’utilisateur doit lire et comprendre le manuel d’utilisation de son tondeuse électrique autoportée avant d’employer cet accessoire.
- Página 6 NOTE : Si nécessaire, soulever la tondeuse en la plaçant sur TIGE POUR un pont élévateur ou en utilisant un vérin de levage et des LAME TIGE POUR chandelles ou retirer le plateau de coupe comme décrit au CERCLE ARBRE LAME DEMI- chapitre précédent afin d’avoir accès aux lames.
- Página 7 TROU ARBRES DU CHÂSSIS COUVERCLE TUBE SUPÉRIEUR OUVERTURE DU COUVERCLE Fig. 8 Fig. 5 COUVERCLE TUBE SACS INFÉRIEUR CHÂSSIS LOQUET LOQUET Fig. 9 Fig. 6 TUBE SUPÉRIEUR LANGUETTE LOQUET TUBE INFÉRIEUR Fig. 7 Fig. 10 Installer le tube d’ensachage inférieur du côté de la buse de ensemble et en alignant le trou de la languette du tube décharge en plaçant l’ouverture sur la languette du châssis inférieur avec la languette du tube supérieur.
- Página 8 UTILISATION DE LA TROUSSE D’ENSACHAGE INDICATEUR DE Voir les figures 11 et 12. SAC PLEIN AVERTISSEMENT : Les accessoires ajoutés peuvent nuire à la stabilité de la tondeuse pendant la coupe effectuée sur des pentes. Effectuer les déplacements de tondeuse sur les pentes avec grande prudence lorsque la trousse d’ensachage est installée.
-
Página 9: Juego Para Embolsar Acrm005
JUEGO PARA EMBOLSAR ACRM005 PARA USAR CON LA PODADORA ELÉCTRICA DE GIRO CERO RYOBI ADVERTENCIA: CABLE (x2) Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la podadora de pasto tipo tractor antes de usar este accesorio. Guarde estas instrucciones. - Página 10 NOTA: Si es necesario, levante la podadora colocando un MONTANTE elevador o utilizando un gato hidráulico y un gato estabilizador, DE LA MONTANTE DE o remueva la base de corto tal como se describe en la sección CUCHILLA LA CUCHILLA anterior antes de tener acceso a las cuchillas.
- Página 11 ORIFICIO EJES DEL BASTIDOR CUBIERTA TUBO SUPERIOR ABERTURAS DE LA CUBIERTA Fig. 8 Fig. 5 CUBIERTA BOLSAS TUBO INFERIOR BASTIDOR PESTILLO PESTILLO Fig. 9 Fig. 6 TUBO SUPERIOR LENGÜETA PESTILLO TUBO INFERIOR Fig. 7 Fig. 10 Instale la parte superior del tubo superior para embolsadora ...
-
Página 12: Mantenimiento
CÓMO USAR EL JUEGO PARA EMBOLSAR INDICADOR DE Vea las figuras 11 y 12. BOLSAS LLENAS ADVERTENCIA: Los accesorios agregados pueden afectar la estabilidad de la podadora si se usa en pendientes. Tenga sumo cuidado cuando pode en pendientes si el juego para embolsar está instalado.