Ryobi AC04154 Manual Del Usuario

WARNING!
To reduce the risk of injury, user must read and understand the operator's manual
for their lawn mower and this instruction sheet. Always wear eye protection with
side shields marked to comply with ANSI Z87.1. Ensure compatibility and fit
before using this accessory. Do not use this accessory if a part is damaged or
missing. If you are not comfortable performing any of the functions described
in these instructions, take your unit to a qualified service center.
WARNING:
Always protect hands by wearing heavy gloves and/or wrapping the cutting edges
of the blade with rags and other material when performing blade maintenance.
Contact with the blade could result in serious personal injury.
REPLACING THE CUTTING BLADE
See Figures 1 - 2.
 Stop the motor and remove the key. Allow blade to come to a complete stop.
 Remove battery pack.
 Turn the mower on its side.
 Wedge a block of wood between the blade and mower deck to prevent the blade
from turning.
 Loosen the blade nut by turning it counterclockwise (as viewed from bottom of
mower) using a 15 mm wrench or socket (not provided).
 Remove the blade nut, spacer, blade insulator, and blade.
 Make certain the blade carrier is pushed completely against the motor shaft.
 Place the new blade on the shaft against the blade carrier. Ensure blade is
properly seated with shaft going through center blade hole and the two blade
posts inserted into their respective holes on the blade. Make sure it is installed
with the curved ends pointing up toward the mower deck and not down toward
the ground. When seated properly, the blade should be flat against the blade
carrier.
 Replace the blade insulator and spacer, then thread the blade nut on the shaft
and finger tighten.
NOTE: Make certain all parts are replaced in the exact order in which they were
removed.
 Torque the blade nut down clockwise using a torque wrench (not provided) to
ensure the bolt is properly tightened. The recommended torque for the blade
nut is 350-400 in. lbs.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
991000851
4-30-18 (REV:03)
LAWN MOWER BLADE
AC04154
For use with RYOBI
16 in. Lawn Mowers ONLY
1428 Pearman Dairy Road
Anderson, SC 29625 USA
1-800-860-4050
www.ryobitools.com
®
Fig. 1
A - Blade (lame, hoja)
B - Wrench (clé, llave)
C - Block of wood (pièce de bois, bloque de
Fig. 2
A - Blade carrier (support de la lame, soporte de
B - Blade post (round) [tiges pour lame (ronde),
C - Shaft (arbre, eje)
D - Blade post (half circle) [tige pour lame (demi-
E - Blade hole (round) [trou pour lame (ronde),
F - Blade (lame, hoja)
G - Blade hole (half circle) [trou pour lame (demi-
H - Blade insulator (isolant de lame, aislante de
I - Spacer (entretoise, separador)
J - Blade nut (écrou de lame, tuerca de la hoja)
G - Blade posts (tiges pour lame, montantes de
A
C
madera)
B
G
A
B
E
H
J
la hoja)
montantes de cuchilla (Redondo)]
cercle), puerto de la hoja (semicircular)]
orificio de la hoja (redondo)]
cercle), orificio de la hoja (semicircular)]
hoja)
cuchilla)
B
G
C
D
F
G
I