BLACK&DECKER LZR4 Manual De Instrucciones página 4

ENGLISH
An exposure of the eye to the beam of a class 2 laser is
u
considered safe for a maximum of 0.25 seconds. Eyelid
reflexes will normally provide adequate protection. At
distances over 1 m, the laser complies with class 1 and
thus is considered completely safe.
Never look into the laser beam directly and intentionally.
u
Do not use optical tools to view the laser beam.
u
Do not set up the tool at a position where the laser beam
u
can cross any person at head height.
Do not let children come near the laser.
u
Warning! This tool is intended for indoor use only. Do not use
the tool for outdoor applications.
Residual risks.
Additional residual risks may arise when using the tool which
may not be included in the enclosed safety warnings. These
risks can arise from misuse, prolonged use etc.
Even with the application of the relevant safety regulations
and the implementation of safety devices, certain residual
risks can not be avoided. These include:
Injuries caused by touching any moving parts.
u
Injuries caused by touching any hot parts.
u
Injuries caused when changing any parts or accessories.
u
Injuries caused by prolonged use of the appliance. When
u
using any appliance for prolonged periods ensure you take
regular breaks.
Safety of others
This appliance is not intended for use by persons (includ-
u
ing children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their
safety.
Children should be supervised to ensure that they do not
u
play with the appliance.
Features
This appliance includes some or all of the following features.
1. On/off switch
2. Operating mode selector
3. Laser aperture
4. Battery cover
Fig. A
5. Tripod
6. Hanging strap
4
(Original instructions)
Assembly
Warning! Make sure that the tool is switched off.
Fitting the battery (fig. B)
Remove the battery cover (4) from the tool.
u
Connect the battery to the connector. The larger battery
u
terminal connects to the smaller connector terminal.
Refit the cover and let it click into place.
u
Installing the tool (fig. A, C & D)
The tool can be installed on a horizontal surface such as
a floor or a table. Alternatively, the tool can be mounted on
the tripod (5). The tool can also be hung from a joist or other
secure structure using the hanging strap (6).
Note: the laser lines will only be level if the tool is kept within
5° from vertical.
Mounting the tool on the tripod (fig. C)
Align the threaded screw (8) on the tripod with the laser.
u
Screw the laser to the tripod and make sure that it is
u
secure.
To remove the tool, unscrew the laser from the tripod.
u
Hanging the tool (fig. A & D)
Thread the hanging strap (6) through the slot in the top of
u
the tool and fasten the hook.
Adjust the tool so that it hangs relatively level.
u
Installing and adjusting the tripod (fig. A & E)
Installing
Choose a smooth and level surface to install the tripod.
u
Flip open the lever locks (7) (fig. A) and extend the legs to
u
the required length.
Flip the lever locks closed to lock the legs.
u
Mount the tool to the tripod.
u
Adjusting
Loosen the locking knob (10) (fig. E).
u
Pull out the fold-away handle (9) and rotate it until the
u
required height is reached.
Tighten the locking knob (10) to secure the tripod at the
u
adjusted height.