SODECA SI-VOC+HUMEDAD Manual Del Usuario página 8

Idiomas disponibles

Idiomas disponibles

Once activated, the number of hours the equipment has been operating will be shown.
LCD value
000
001
190
200
To reset the operating hour counter the equipment must be in the "reset mode" and the
pressed for more than 2 seconds.
9. Button instructions
Press for more than 2 seconds to switch the device lamp on or off.
Select it to change the working mode to Manual-Automatic-Timer-Off.
Select it to increase the fan speed or to add the setup value.
Select it to reduce the fan speed or to reduce the setup value.
Press the button while the CO
NOTE: Before carrying out the above action, the user must select the controller in the automatic mode.
Press the button while the temperature value flashes to select the automatic temperature mode. The
temperature value will flash and the user can change it using
NOTE: Before carrying out the above action, the user must select the controller in the automatic mode.
Press the button while the temperature value flashes to select the automatic humidity mode. The
temperature value will flash and the user can change it using
NOTE: Before carrying out the above action, the user must select the controller in the automatic mode.
10. Technical characteristics
Nominal voltage
Power on Standby
Control power
Surge protection
Output interface
Heating time
Response time
Recovery time
Operating temperature
Storage temperature
Operating humidity
Storage humidity
11. Disposal
Careless or negligent disposal of the equipment may cause contamination. The disposal process must be carried out in
compliance with the standards and regulations applicable in the country.
12. Warranty
Incorrect use of the equipment and failure to observe the instructions in this manual may result in the cancellation of the
warranty.
Real time value
0G9
10G19
1900G1999
2000G2099
Filter change alarm
value flashes to select the automatic CO
2
AC 220V, 50/60Hz.
<1.5 W
200 W
5A fuse
High speed / medium speed / low speed
60 seconds
10 seconds
30 seconds
-10°C --- +50°C
-10°C --- + 60°C
95% RH
60% RH
button must
mode.
2
and
and
loading