Luna MINI ASM 5-A1 Manual De Instrucciones página 22

• Do not wear loose long hair, loose clothing or jewellery, which could become
caught up in moving parts of the tool and cause injuries and clothing damages.
• A switched-on tool may be directed towards the work material only. Loose parts
may disunite and cause damages. A person or an object may become in contact with
the tool, which could cause an accident or material loses.
• Cold or wet hands, smoking and snivel may increase vibration caused hazards.
• Let the tool operate and by holding the handle use the least possible force.
If possible, the tool should be supported on a stable support block.
• Interruption of work should be ensured or another kind of work, not involving use
of vibrating tools should be alternatively performed, in order to reduce the harmful
influence caused by the vibration.
• Ensure that the workplace is well lit
Tools must be lubricated
Before use always lubricate the tool with a few drops of oil AIRTOIL 22 (Luna
15531-0105) intended for use with pneumatic tools, by dropping it into the air inlet
opening of the tool. In case of continuous work, a pneumatic lubrication system (Luna
20571-0106) should be used, adjusted to about two drops per minute. If the tool is not
used for a longer period of time, it is required to drop a few drops of oil before storage
of the tool, in order to reduce the corrosion risk.
Attention! Use only oil that is supposed for pneumatic tools. Use of other oils may
result in "clumping" of oil and reduction of the movement ability of the machine.
It may cause reduced work efficiency.
Leakages must be avoided
Avoid leakages in the air circulation system. Always use a thread sealing tape at the
point where the plug is connected to the tool. Pay attention that hoses and hose clamps
are in good conditions.
The compressed air must be dry
As cleaner and dryer the compressed air is, the longer is life time of the tool.
In order to ensure it, we recommend use of air filter, which removes water from the
compressed air, accordingly reducing eventual damages of the tool and connections
caused by corrosion. Remember to remove eventual water condensate from the com-
pressor tank and the compressed air supply system before each working day.
Remember!
Important information
22