Idiomas disponibles
Idiomas disponibles
DIP SWITCHES
When set to Off, it allows line-level signal
input through channel 1. When set to
CH1 MicOn/LineOff
On, it allows microphone-level signals
through channel 1.
This switch sets channel 1 to normal,
CH1 Normal
with no priorities.
Enables
priority circuit on input 1 is closed.
CH1 Priority
Connect the priority connection on Input
1 to microphone's push-to-talk function
when this is activated.
Activating this switch allows automatic
CH1 VOX
muting when channel 1 input passes the
preset threshold.
Activating this switch sends the channel
CH1 to Zone 2
1 input signal to the zone 2 output
channel.
Activating this switch sends the channel
CH2 to Zone 2
2 input signal to the zone 2 output.
Activating this switch will reduce the
input signal level of channel 2 by 28
CH2 PAD
dB making it ideal for low-impedance
devices.
This switch activates phantom power
to the Input 1 input. Phantom power
Phantom Power
is required for use with condenser
microphones.
INPUT WIRING
Phonic recommends that customers use pre-built balanced line
connectors with 22 to 24 gauge cable. Unbalanced connections could
also be used however are susceptible to noise.
Priority Muting
Phonic's mixer/amplifiers allow
users to mute background
signals
in
favour
of
the
microphone/line input 1 signal.
To use a microphone's push-
to-talk switch, first connect
the mic's push-to-talk contact
switch to the priority connector
of the Mic/Line input. Ensure
the CH1 Normal DIP switch is
set to OFF and the CH1 Priority
DIP switch is set to ON. This
enables users to mute all other
signals when the microphone's
push-to-talk button is engaged.
muting
of
channels
when
http://www.phonic.com
GA335 / GA460 EASY MANUAL
OUTPUT WIRING
Speakers
Output to speakers can be achieved by slipping cable lugs
underneath the output screw terminals. Tighten screws to fasten
in place. Customers may choose to use crimp-on spade lugs.
Phonic recommends that customers use professionally wired high
gauge cables. The plastic cover can be slid into place to protect
connections. It is recommended that you insulate exposed wires
to help prevent against the possibility of short-circuits. Class 2
wiring is required.
The GA335 offers 35 Watts of power while the GA460 offers 60
Watts (whether using 8 ohm or direct voltage 70V/100V output).
Zone 2 / MOH
External music sources can be
sent over phone lines while a
caller is on hold using the Phonic
CMx series. Connections can be
completed as indicated below
using either the 8 ohm or 600
ohm connections. Connect the
Zone 2/MOH to your telephone
system or PBX's music-on-hold
input.
WARNING: Do not use shielded
cable for output power wiring.
Phonic recommends use of
2-conductor shielded cable and
3-pin Euroblock connectors for
Preamp Line output.
To telephone system
interface/PBX input
