Team kalorik TKG VT 1019 Manual De Instrucciones página 9

Fax +32 2 359 95 50
It is absolutely necessary to unplug the appliance before
assembling the base or any other part or before disassembling it.
Make sure the assembly is correctly made before plugging in the
appliance. Never try to start the appliance without its protection
guard.
Make sure the appliance is switched to the "0" position before
unplugging it.
Do not insert your fingers, pencils, or any other objects in the
protection guard.
Do not touch the appliance with wet hands.
Do not put the fan on a window sill or any other unsteady place.
Make sure the appliance is put on a flat surface in order to avoid
vibrations.
When used in an inappropriate manner the appliance could
constitute a danger to the user, in that case the producer cannot
be held responsible for any kind of possible damages.
Do not let the fan in use for long periods during your absence.
Make sure it is switched off before leaving.
Do not point the fan in the direction of a sick or sleeping person.
When cleaning the appliance, do not disassemble the guards,
check the cleaning section.
(*) Competent qualified electrician: after-sales department of the
producer or importer or any person who is qualified, approved and
competent to perform this kind of repairs in order to avoid all danger.
In case of need you should return the appliance to this electrician.
ASSEMBLY (see picture page 2)
•
Before mounting the appliance, make sure it is unplugged.
•
Put the rear base (3) onto the motor support (4).
•
Pass the power cord (1) through the central gate of the rear base (3) and insert it in the
wire casing.
•
Firmly clamp the rear base (3) with the front base (2), coordinate the position of the motor
support.
•
Then tighten the two nuts, and put the appliance on a dry firm and level surface.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
9
Assembly page 9/45
TKG VT 1019 - 151120