Conceptronic CFULLHDMAi Manual Del Usuario página 55

ENGLISH
- Aspect Ratio
- Use HDMI EDID
Audio Setup
- Digital Audio Output
- Analog Audio Output
Video Setup
- Brightness
- Contrast
- Hue
- Saturation
Other Settings
- Screen Saver
- Photo Display Setup
- Side Show Time
- Music Auto Play
- Video Resume Playback Change the Video Resume mode. (Ask, Always, Off)
- Play Next Video
- Advance
When the settings are changed, press the 'Back' (8) button on the remote control to return to the main
Setup menu.
6.3 Version
In the 'Version' menu, you can see the current firmware version or upgrade your firmware.
Reset To Default
Firmware Upgrade
- Internet Upgrade
- USB Upgrade
Note: Do NOT power off the unit when you are upgrading the firmware. This will damage the unit and
makes it unusable!
When the settings are changed, press the 'Back' (8) button on the remote control to return to the main
Setup menu.
When you are finished with the Setup of the unit, press the 'Back' (8) button or the 'Home' (27) button
on the remote control to return to the main menu.
Select the aspect ratio of your TV. (4:3 LB, 4:3 PS, 16:9)
Enable or Disable the use of HDMI EDID.
(EDID = Extended Display Identification Data. If your TV supports EDID, it will
send the available resolutions and aspect ratios automatically to the unit)
Set the output signal for the digital output. (Off, RAW or PCM)
Set the output signal for the analog output. (Stereo, Mono L/R, Mix Mono)
Change the brightness of the output signal.
Change the contrast of the output signal.
Change the hue of the output signal.
Change the saturation of the output signal.
Set the inactivity time for the screensaver. (Off, 1~30 minutes)
Change the way photo's are shown. (List, Thumbnail)
Change the time between 2 photo's in a slideshow.
(1~30 seconds, 1~3 minutes)
Change the Music Autoplay mode. (Off, One Time, Repeat)
Play the next video when a video is finished. (Enable, Disable)
In the 'Advance' menu, you can enable or disable the Network LED of the
CFULLHDMAi.
Set the unit back to the factory default settings.
Upgrade the firmware through the internet. The unit will automatically
search online for a new version if the unit is connected to the internet.
Upgrade the firmware through a USB storage device.
55