Scope Of Supply; Technical Data Dh 40; Installation And Commissioning; Planing - Proxxon ВР 40 Manual De Instrucciones

The height of the planing table 4 and thus the planing
thickness can be conveniently and reliably adjusted by
means of the large hand wheel 2 on the top of the
housing.
Caution!
The planer is equipped with a so-called re-start protection
facility. If the supply is interrupted for a short time during
operation, the planer will not re-start automatically for
safety reasons. However, in this case, the planer can be
started normally by means of the "on" switch.

Scope of supply

1 off Thickness planing machine DH 40
1 off Pin for height adjustment hand wheel
1 off Operating manual

Technical data DH 40:

Voltage:
Power:
Max. pass-through height:
Max. pass-through width:
Length of planing table:
Swept diameter of shaft:
Planing cutter length:
Cutters:
Planing shaft speed on no-load:
Max. planing reduction:
Feed speed:
Sound pressure level:
Sound power level:
Vibration:
Dimensions:
Length:
Height:
with hand wheel:
Width:
Weight:
1. For use in enclosed rooms only!

Installation and commissioning

Caution!
Please check the thickness planer immediately for
possible transit damage. Damage to the packaging may
220 – 240 Volt,
50/60 Hz
200 Watt
KB 15
40 mm
80 mm
232 mm
48 mm
82 mm
2-off HSS reversible
cutters
6000 rpm
0.8 mm
4.8 m/min
ca. 85 dB(A)
ca. 98 dB(A)
≤ 2.5 m/s2
280 mm
232 mm
300 mm
225 mm
ca. 8 kg
indicate incorrect handling during shipping. It is essential
that transit damage should be reported immediately to the
dealer or to the shipping company concerned.
Note:
The foundations for the erection of the planer must be
firm, clean and dry.
1. To erect the planer, remove the machine from the
packaging and place
foundation.Ensure that the machine is standing safely
and that it cannot fall during operation.
2. It is recommended that the machine be bolted to the
foundations. There are 4 holes in the die-cast
aluminium feet for
accommodate M5 Allen screws (not included in the
scope of supply).
3. Screw the pin 1 (Fig. 2) onto the hand wheel of the
planer using an Allen Key.
Caution:
Before plugging in the mains plug, please check whether
the information on the rating plate corresponds with the
characteristics of your local electricity supply.
4. Plug in the mains cable.

Planing

Caution:
Never use your hand to reach into the infeed slot while
the planer is in operation! Risk of injury!
Caution:
The service flap must always be closed during operation.
The planer is now ready for operation. The height of the
planing table 2 and thus the pass-through height and the
depth of cut (i.e. the "planing depth") can now be set on
the hand wheel 1 (Fig. 3). The position of the planing
table must, of course, first be set roughly to the thickness
of the workpiece. This can expediently be estimated by
means of the linear scale 3 at the side of the inlet
opening. The value printed here gives the distance
between the tips of the planing cutters and the surface of
the planing table. If this value is the same as the thick-
ness of the workpiece, the depth of cut (i.e. the "shaving
thickness" so to speak) is exactly "zero".
Note:
It is recommended that the opening be set rather
"generously" and the workpiece run through a few times.
on a flat and
this purpose, which
- 11 -
level
will