Troubleshooting - Silverline 633630 Manual De Instrucciones

GB

Troubleshooting

Problem Possible cause Solution
Pressure incorrect Set the correct air pressure according to the specification
Dirt within the mechanism Pour oil into air inlet as per maintenance instructions
Tool operating slowly
Air blockage Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by re-tightening, using
Air leak
PTFE tape or replacing
Dirt or rust in mechanism See 'Tool operating slowly' solutions
Tool seized Dirt or rust in mechanism Tap tool gently with a soft mallet
Dirt or rust in mechanism Free mechanism by rotating drive manually when disconnected from air line
Accessory fitted incorrectly Remove accessory, inspect for damage and refit
Strong vibrations when tool is
Accessory damaged (cracks, deformations or splinters) Replace cutting accessory
switched on
Spindle bent Have the tool repaired by an authorised Silverline service centre
Tool will not stop after trigger is
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8