Stocker Magma E-35 TP Manual De Instrucciones página 77

Pruning shears Magma E-35 TP - Pruning shears Magma E-35 TP with telescopic handle
7
1. If the pruners stop working during long term use and you hear 4 fast beeps, this is an indica-
tion of undervoltage protection which means the battery is depleted. Please charge as soon
as possible.
2. In order to conserve the use of battery power and ensure that the pruning shears have the
longest service life, do not overload the device and avoid cutting branches with a diameter
larger than 35 mm.
3. During the shearing process, if the shearing knife encounters a branch that cannot be cut off,
then release the trigger to reopen the blades, after which the next normal shear session can
be carried out.
The blades of the pruner should not be moved around while cutting, so as not to
damage the blades. Never move the pruner side to side when wedged.
Reading the LED display
To determine the shears' battery charge level and keep the count of the performed cuts
(Table 1), the shears are equipped with a LED display.
On the LED display it is also possible to read other signals about maintenance and faults
(Table 2).
152
Art. 312 / Art. 582 / Art. 583
Usage
Art. 312 / Art. 582 / Art. 583
Pruning shears Magma E-35 TP - Pruning shears Magma E-35 TP with telescopic handle
Usage
Display
(Table 1)
Code Description
1
Software high current
3 PCB Current error
4
Gear stuck or jammed
5 Low voltage
6
High voltage
7
Hardware high current
9
Battery low capacity
10
Geared motor disconnected
11
Hall sensor error
(Table 2)
For further information about the product, please contact [email protected]
7
Description
Battery 80 - 100 %
Battery 50 - 80 %
Battery 30 - 50 %
Battery under 30 %
The total number of performed cuts is displayed within
10 seconds from the swtich-on. Subsequently the dis-
play shows the amount of cuts from the switch-on.
Solution
Replace the PCB
Replace the PCB
Replace the geared motor
Charge the battery
Replace the PCB
Replace the PCB
Charge the battery
Reconnect the cables or replace the geared
Replace the geared motor
153