Tektronix MDO3000 Serie Instalación página 11

Troubleshooting Module Installation
MDO3000 Series Application Module Installation
1. Power off the oscilloscope.
2. Remove the module and examine the contacts for damage or contamination.
Clean contacts if necessary using a 75% isopropyl alcohol solution.
3. Reinstall the module into the oscilloscope.
4. Power on the oscilloscope, and perform the Checking Module Installation
procedure. (See page 4.)
a. If the Application Module Enabled display lists the application module as
enabled, cleaning the contacts fixed the problem.
b. If the Application Module Enabled display does not list the application
module as enabled, go to step 5.
5. Power off the oscilloscope and move the module to another slot.
6. Power on the oscilloscope, and perform the Checking Module Installation
procedure. (See page 4.)
a. If the Application Module Enabled display lists the module as enabled,
you have a problem with one of the module slots. Contact your Tektronix
service center.
b. If the oscilloscope does not list the module as enabled after you try the
module in every slot, contact your Tektronix service center.
Checking Module Installation
5