Kohler K-T18488 Guia De Instalacion página 8

Retainer
Spacer
Screws
Faceplate
Pivot Ring
Valve Stem
Screw
Stem Adapter
O-Ring
Discard dome.
Handle Assembly
5. Install the Trim
Remove and discard the plaster guard and/or dome from the
valve stem, if installed.
For wall thickness of 3/16" (5 mm) to 7/16" (1.1 cm): Attach the
retainer to the valve stem with the #10 screws provided.
For wall thickness of 7/16" (1.1 cm) to 3/4" (1.9 cm): Place the
spacer onto the valve stem, then attach the retainer to the valve
stem with the #10 screws provided.
Install the faceplate onto the retainer. The cutout on the faceplate
should face downward.
Install the pivot ring to the faceplate, and rotate clockwise to lock
in place. The pivot ring should be situated with the cutout
aligned with the faceplate cutout.
Rotate the valve stem fully counterclockwise to the "OFF"
position.
Position the deep end of the stem adapter onto the valve stem.
The outer sides of the stem adapter should be positioned as
horizontal and vertical as possible.
Attach the stem adapter with the supplied screw.
Ensure the O-ring is positioned in the groove on the inside of the
handle assembly.
Align the handle to the "OFF" position. Hold the handle in the
"OFF" position and thread the handle assembly securely onto the
retainer.
1054205-2-B 8 Kohler Co.