SNOWJOE SWITCHSTIK SJ-HS101 Manual De Instrucciones página 3

EN
Connecting Interchangeable
Heads
1. Press down the release button (Fig. 1).
Fig. 1
Release button
Handle
2. Install tool attachment (tool head) on
the SUN JOE SwitchSTIK.
• The release button (located in the
handle) must be held down while
installing the attachment.
• The flats on the SwitchSTIK tip
must be aligned with the flats on the
attachment socket in order for the
SwitchSTIK to be fully engaged and
work properly (Fig. 2).
Fig. 2
Flats on the
SwitchSTIK tip
Locking
mechanism
• To align the flats, simply twist the
attachment while installing. The
attachment will bottom out on the
handle when the flats are properly
aligned and prevent the attachment
from rotating (Fig. 3).
Fig. 3
Tool attachment
m
CAUTION!
release button while using the SUN JOE
SwitchSTIK. Doing so could cause the
attachment to become disconnected and
serious injury could result.
SUN JOE SwitchSTIK Care
1. For optimal performance it is
important to keep the locking tip and
attachments free of dirt and debris.
Locking Tip: Rinse the locking tip
with water. DO NOT PUSH THE
RELEASE BUTTON. Doing so could
result in debris getting into the ball
joints impeding the performance of the
locking tip mechanism.
Attachments: To remove debris, rinse
attachments with water.
Removing Interchangeable
Heads
Flats on the
1. Press down the release button
attachment
(located in the handle) (Fig. 4).
socket
NOTE: The locking mechanism is
designed to be engaged at all times
and is only deactivated when the
release button is pressed.
2. Grasp tool attachment firmly, and
remove (Fig. 4).
NOTE: The release button must
be held down while removing the
attachment.
3
Handle
Do not push the