Powis Parker FASTBACK 8x Manual Del Usuario página 11

All manuals and user guides at all-guides.com
BINDING A DOCUMENT WITH
V-C
PERFECTBACK® PS Lx-STRIPS™
1. If necessary, switch to Perfectback PS mode (see Section VII, page
15). If the machine is already in Perfectback PS mode, the display
reads "READY TO BIND" ... "PERFECTBACK PS".
2. Select your Perfectback strip according to your document thickness:
10-125 sheets= Narrow Perfectback® PS Lx-Strip™
25
F I G U R E
125-250 sheets = Medium Perfectback® PS Lx-Strip™
(This may vary slightly depending on the paper and cover thickness.)
•
HINT:
your document in the binding recess and push the BIND button.
The correct width will be shown on the display.
26
F I G U R E
3. Follow steps 3 through 9 on page 7 to bind your book block.
4. Score and fold your cover at the two positions that will represent
your spine edges (Figure 25).
•
Tip:
accurately for you.
5. Peel off the thin release paper at the front of your book block
27
F I G U R E
(Figure 26).
6. Place your pre-folded cover on a flat surface with the front of the
cover bent up from the rear spine edge. Insert your book block
inside the front of your cover. Position it so full and even contact is
made in the spine area. (Figure 27)
7. Fold your front cover tightly over the book block.
28
F I G U R E
Starting from the middle, rub back and forth to secure the cover to
the adhesive strip beneath it (Figure 28).
8. Flip the book over. Open the back cover and peel the remaining
release paper away from the spine, starting with the top edge
(Figure 29).
9. Tightly pull the cover against the spine. Rub back and forth, starting
29
F I G U R E
from the middle, to bind the back cover to the adhesive beneath it
(Figure 30).
10.
30
F I G U R E
FASTBACK MODEL 8x USER'S MANUAL, L4079 Rev. C 04/08/05
If you are not sure which strip width to use, simply place
The Powis Parker Scoring Machine can do this quickly and
Trim the book ends as desired.
11