AP 4200
When the dust container reaches the MAX fill line indicated on the side of the product, it will need to be
emptied. This will help it to maintain suction performance.
1. To remove the dust container, press the release button located just above where the container is
attached.
2. Pull the dust container away from the unit.
3. Over a bin, remove the whole filter assembly and tap off the trapped dirt. Tip the container upside
down to empty the contents. You may need to tap the sides to dispose of all of the dirt.
Important: You may wish to empty the dust container outdoors as emptying may create a dust
cloud.
4. Place the filter back into the dust container in the direction indicated by the diagram.
5. Place the assembled dust container back onto the unit and click into place.
Cleaning the filter
It is necessary to clean the filters regularly with frequent use in order to maintain suction performance and
prolong the life span of your cleaner.
1. Follow steps 1 to 3 on the previous page.
2. Carefully wash the filter in warm water and allow drying for 24 hours. Also clean the dust container
in the same manner.
3. Once dried, place the filter back into the dust container in the direction indicated by the diagram.
4. Place the assembled dust container back onto the unit, until it clips into place.
After around 6 months of regular use the filters may need replacing.
Floor head brush maintenance
If any threads or hairs get trapped in the brush you may need to carry out maintenance.
For regular maintenance, pull out the waste from around the bar.
If you cannot manually rotate the brush, unlock the cover and remove the brush to clean it.
When reinserting, make sure the brush cover is securely fixed and that the brush rotates properly.
Before you clean the appliance, make sure the power is switched off and that the unit is not on the charging
stand.
It is recommended to store the appliance on the charging stand. Do not leave plugged in for extended
periods of time.
20