Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Maintenance
WARNING: ALWAYS disconnect the tool from the power supply, before cleaning or
carrying out maintenance.
• Inspect the supply cord of the tool prior to each use for damage or wear. Repairs should
be carried out by an authorised Triton service centre. This advice also applies to extension
cords used with this tool
General inspection
• Regularly check that all the fixing screws are tight. They may vibrate loose over time
Lubrication
• Lubricate all moving parts with a suitable lubricant spray, at regular intervals
Changing the saw blade
WARNING: ALWAYS wear cut-proof gloves when handling saw blades.
IMPORTANT: Never fit a damaged, heavily worn or blunt saw blade.
IMPORTANT: The saw blade rpm must match or exceed the no load speed of the tool (see
specification).
1. Turn the device on its back, with the bottom of the Base (12) facing upward
2. Unscrew the Blade Access Knob (21) until the Base Lid (31) can be raised. Ensure the Fence
(30) is at a height away from the Base
3. Press the Spindle Lock Button (2) and use the supplied pin spanner to remove the Threaded
Blade Flange (33)
4. Remove the Saw Blade (32)
5. Insert a new Saw Blade of identical type and dimensions (see 'Specification')
WARNING: ALWAYS observe the direction of rotation, as indicated by the Direction Indicator
(35 & 3).
6. Refit the Threaded Blade Flange, press in the Spindle Lock Button and tighten the Threaded
Blade Flange with the pin spanner
7. Release the Spindle Lock Button, lower the Base Lid and re-tighten the Blade Access Knob
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and gloves when
cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, a mild
detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation holes (where
applicable)
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
To replace the brushes;
1. Remove the Handle Screws (20) that secure the Main Handle (18) housing
2. Remove the two sides carefully making sure not to pull or damage the cables
3. Carefully use a screwdriver to push in the small notch at the front indicated by the lower
arrow (Image I)
4. Carefully press in the other side of the brush base as indicated with the upper arrow then
carefully remove the brush from the brush housing
5. Remove both worn brushes and replace with new (Image J)
6. Refit the housing carefully then insert and tighten the Handle Screws
• Alternatively, have the machine serviced at an authorised Triton service centre
Note: Always replace carbon brushes in pairs.
GB
10
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Tabla de contenido
