Fiap Fountain Active Manual Del Usuario página 3

FIAP Fountain Active
Gerät zusammenbauen:
Gerät in umgekehrter Reihenfolge zusammenbauen.
Lagern / Überwintern
Bei Frost muss das Gerät deinstalliert werden. Führen Sie eine gründliche Reinigung durch, prüfen Sie
das Gerät auf Beschädigung. Bewahren Sie das FIAP Fountain Active getaucht und frostfrei in einem
Behälter mit Wasser auf. Der Stecker darf nicht überflutet werden.
Entsorgung
Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen.
Fragen Sie Ihren Fachhändler.
Störungsbeseitigung
Störung
Pumpe schaltet nicht ein Netzspannung fehlt
Fontänenhöhe ungenügend Laufrad blockiert oder verschmutzt
Gerät schwimmt auf Filterschale verschmutzt
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30;
Ursache Abhilfe
Netzspannung überprüfen
Zuleitung kontrollieren
Laufrad reinigen
Filterschale reinigen
www.fiap.com
FIAP Fountain Active
GB
Information about this operating manual
Please read the operating instructions and familiarise yourself with the unit prior to using it for the first
time. Adhere to the safety information for the correct and safe use of the unit. Please keep these
operating instructions in a safe place! Also hand over the operating instructions when passing the
unit on to a new owner. Ensure that all work with this unit is only carried out in accordance with these
instructions.
Intended use
The FIAP Fountain Active series, referred to as unit in the following, is a floating water feature fountain
with LED lighting. Only operate the unit with normal pond water at a water temperature between
+4 °C and +35 °C. The unit is suitable to operate in swimming ponds while respecting the national
regulations for installers, and in water basins on patios.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and
in the case of misuse. If used for purposes other than that intended, our warranty and operating permit
will become null and void.
CE Manufacturer's Declaration
We declare conformity in the sense of the EC directive, EMC directive (2004/108/EC) as well as the
low voltage directive (2006/95/EC). The following harmonised standards apply:
EN 55014-1, EN 55014-2, EN 60335-1, EN 60335-2-41, EN 60598-1, EN 60598-2-18, EN 61000-3-2,
EN 61000-3-3, EN 61558-2-6
Packaging
• Floats,
•
Nozzle holder with fountain,
• Pump FIAP Aqua Active 2.500,
•
2 hose clip,
• 1 silicone hose,
•
1 LED ring 14,4 W with 48 white LEDs
Safety information
The company FIAP has built this unit according to the state of the art and the valid safety regulations.
Despite the above, hazards for persons and assets can emanate from this unit if it is used in an
improper manner or not in accordance with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons who
cannot recognise possible danger or who are not familiar with these operating instructions, are
not permitted to use the unit. Hazards encountered by the combination of water and electricity.
The combination of water and electricity can lead to death or severe injury from electrocution, if the unit
is incorrectly connected or misused. Prior to reaching into the water, always disconnect the power
supply to all units used in the water.
5
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30; www.fiap.com
6