Troubleshooting - Worx WG829 Manual Del Usuario

Nozzle maintenance
Clean the openings of any obstructions or residue.
Do not use sharp tools that could scratch or damage
the nozzle.
Hose maintenance
Clean the filter at the end of the hose regularly for a
better performance. (See Fig. J)
Shut-off maintenance
Remove the filter from the shut-off assembly. Clean
the debris inside and clean the filter by rinsing with
cool, clean water. (See Fig. K)
WARNING: Any other servicing should be
performed by an authorized service
representative.
CLEANING AND STORAGE
Empty any extra chemical from the tank. Use clean
water to thoroughly rinse the tank until all chemical
and residues are removed. Use a wet cloth to wipe
the bottom of the pump until all chemical and
residues are removed. Do not rinse the pump with
a hose or submerge in water, as water will enter the
housing resulting in the pump non-functional. With
clean water in the clean tank, spray water through
the hose, shut-off lever, wand, and nozzle for at least
30 seconds to rinse the chemical out. Remove the
pump. Do not put the pump down as it may cause
the pump is contaminated with dirt, grass clippings,
or debris that will enter the tank later. Hanging the
tank upside down to let the sprayer drain. Once the
sprayer is dried, please turn the sprayer upright and
loosely attach the pump to the tank to prevent debris
from entering the tank. Store the machine in a warm,
dry place out of direct sunlight.

TROUBLESHOOTING

The following table gives problems and actions that
you can perform if your machine does not operate
correctly.
Warning: Switch the machine off and remove
the battery prior to any troubleshooting.
Symptom Possible
causes
20V 2 Gallon Yard Sprayer
Sprayer will
not turn on
when power
button is
pressed.
Sprayer turns
on but will not
spray.
Sprayer turns
on but only
sprays at a low
pressure.
Hose leaks at
the tank
Solution
Hose leaks at
the shut-off.
Battery is not
charged. LED Charge Pump
light is not on.
Allow the
Pump is battery to cool
over heated, down. Replace
damaged, or Pump if it is
non-functional. damaged or
non-functional.
Tank is already
Depress the
pressurized
lever to see
so the pump
if the sprayer
is turned off
starts spraying.
automatically.
No liquid is in Add liquid to
tank. tank.
Shut-off is Clean the
clogged shut-off
Nozzle is Clean the
clogged. nozzle..
Pump is not
Tighten pump
attached tightly
to tank.
to the tank
Allow time
Tank has
for pump to
not been
pressurize tank
pressurized
(at least 20
yet.
seconds).
Air leaking
Tighten pump
from tank at
to tank.
seal.
Tank seal is Replace tank
damaged. seal.
Shut-off is Clean the
clogged. shut-off
Nozzle is Clean the
clogged. nozzle.
Cracked,
Replace shut-
swollen or
off assembly.
faulty hose.
Damaged Replace shut-
connection. off assembly.
Cracked,
Replace shut-
swollen or
off assembly.
faulty hose.
Damaged Replace shut-
connection. off assembly.
11
EN