Configuring The Untrust Interface - Juniper Networks NETSCREEN-5GT Guía De Usuario

3. Launch a serial terminal emulation program. (A commonly-used terminal
program is Hilgreave HyperTerminal.) The required settings to launch a console
session with your NetScreen-5GT device are as follows:
–
–
–
–
–
4. Enter netscreen in both the login and password prompts. (Use lowercase
letters only. The login and password fields are both case sensitive.)
C
ONFIGURING THE
Your network uses the Untrust interface on the NetScreen device to connect to the
Internet. If you are setting up your Internet connection for the first time, contact your ISP
for information on your network IP address assignment.
Note: If you access the device for the first time using the ScreenOS WebUI graphical
interface, the Initial Configuration Wizard appears when you log in to the WebUI to guide
you through the configuration described in this chapter. Therefore, only the CLI
commands are shown in this chapter.
• If your ISP gave you a specific, fixed IP address and netmask for your network,
configure the IP address and netmask for the network and the IP address of the
router port connected to the NetScreen device. Enter the following CLI
commands in a Telnet or Console session:
• If your network receives an IP address from a server via DHCP, enter the
following CLI commands in a Telnet or Console session:
• If your network receives an IP address from a server via PPPoE, configure the
user name and password assigned by your ISP. Enter the following CLI
commands in a Telnet or Console session:
NetScreen-5GT
Baud Rate: 9600
Parity: No
Data Bits: 8
Stop Bit: 1
Flow Control: None
U
NTRUST
set interface untrust ip ip_addr/mask
set interface untrust gateway ip_addr
save
set interface untrust dhcp client enable
save
set pppoe interface untrust
set pppoe username name_str password pswd_str
save

Configuring the Untrust Interface

I
NTERFACE
13