Using Telnet; Using A Console Connection - Juniper Networks NETSCREEN-5GT Guía De Usuario

Chapter 2 Configuring the Device
For example, if the IP address of the Trust interface on the NetScreen device is
192.168.1.1/24, enter the following:
192.168.1.1
The NetScreen WebUI software displays the login prompt.
3. Enter netscreen in both the Admin Name and Password fields, then click
Login. (Use lowercase letters only. The Admin Name and Password fields are
both case sensitive.)
The NetScreen WebUI application window appears. (If you access the device for
the first time using the WebUI, the Initial Configuration Wizard appears; refer
to the Getting Started Guide for the NetScreen-5GT.)

Using Telnet

1. Connect your workstation (or your LAN hub) to the Trusted port, as described in
"Connecting the NetScreen Device to the Network" on page
2. Start a Telnet client application to the IP address for the Trust interface.
For example, if the IP address of the Trust interface on the NetScreen device is
192.168.1.1/24, enter the following:
192.168.1.1
3. Enter netscreen in both the login and password prompts. (Use lowercase
letters only. The login and password fields are both case sensitive.)

Using a Console Connection

Note: For the console connection, you require a serial cable with a male DB-9 connector on
one end and female DB-9 connector on the other end.
To establish a console connection:
1. Plug the female DB-9 end of the serial cable into the serial port of your
computer. (Be sure that the DB-9 connector is seated properly in the port.)
2. Plug the male DB-9 end of the serial cable into the Console port of the
NetScreen-5GT device. (Be sure that the DB-9 connector is seated properly in
the port.)
12
5.
User's Guide