Chapter 2 Configuring The Device - Juniper Networks NETSCREEN-5GT Guía De Usuario

Chapter 2
Configuring the Device
This chapter describes how to configure a NetScreen-5GT after you have installed and
connected it to your network and to a power source. After completing the necessary
configurations, users in your network will be able to access the Internet through the
NetScreen device while resources in your network are protected from outside computers.
Note: You must register your product at
services, such as internal antivirus or Deep Inspection Signature Service, can be activated
on the device. After registering your product, use the WebUI or CLI to obtain the
subscription for the service. For more information about registering your product and
obtaining subscriptions for specific services, see the "System Parameters" chapter in
Volume 2 of the NetScreen Concepts & Examples ScreenOS Reference Guide.
Note: If you access the device for the first time using the ScreenOS WebUI graphical
interface, the Initial Configuration Wizard appears when you log in to the WebUI. This
Wizard guides you through the configuration described in this chapter. For more
information about starting the Initial Configuration Wizard, refer to the Getting Started
Guide for the NetScreen-5GT.
NetScreen-5GT
www.netscreen.com/cso
2
so that certain ScreenOS
7