Maintenance - Elnapress 250S Manual De Instrucciones

MAINTENANCE

PADDING AND IRONING COVER FOR THE BOARD
By continuously using your ironing press, the padding flattens and the ironing
is no longer impeccable; therefore, it is necessary to replace the foam and the
board cover when they are worn (see accessories list).
Important: Use only original Elnapress accessories.
The covers can be washed at 30°C.
CLEANING OF THE HEATING SHOE
The heating shoe requires simple cleaning. We recommend at each use,
before turning off the machine, to pass a soft cloth over the entire surface of
the shoe.
For cleaning your press, you must use only Elnapress "cleaning liquid" that
you will find among the various accessories that can be purchased separately.
Never use cleaning products other than this specific one or steel wool pads
or abrasive products.
To clean the heating shoe with Elnapress "cleaning liquid":
— Turn on Elnapress, position the temperature on silk. Once the temperature
has been reached, disconnect the electric cable directly from the press.
— Turn the press over on a level, so that the heating shoe looks towards you.
Be careful that the cover is not scratched.
— Spread the cleaning liquid with a microfiber cloth and wipe the entire shoe
surface. Once finished remove the halos from the shoe by wiping with a dry
micro-fiber cloth.
— After cleaning the heating shoe, recreate a thin layer of protection using
the "Heating shoe protection liquid" (optional accessory) on the surface of
the shoe.
Switch on and position at maximum temperature.
Spread the stick in the highest part of the shoe, still upside down, and during
the descent towards the lower part spread the liquid over the entire surface of
the shoe with a soft or microfiber cloth.
Wait for the automatic shut-off. After cleaning we recommend using a
protection between the shoe and the cover board to avoid possible stains.
26 27