Fiap UV Active 15 W Manual De Instrucciones página 3

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
FIAP UV Active
Störung
Störung
Ursache
Das Gerät erbringt zufrieden
Wasser ist extrem verschmutzt
stellende Leistung
Quarzglas ist verschmutzt
UVC-Lampe hat keine Leistung
mehr
UVC-Lampe leuchtet nicht
Netzstecker nicht angeschlossen
UVC-Lampe defekt
Anschluss defekt
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30; www.fiap.com
Abhilfe
Algen und Blätter aus dem Teich
entfernen, Wasser tauschen
Quarzglas reinigen
Die Lampe muss nach 9000
Betriebsstunden erneuert
werden
Netzstecker anschließen
UVC-Lampe austauschen
Elektrischen Anschluss
überprüfen
5
FIAP UV Active
GB
Information about this operating manual
Please read the operating instructions and familiarize yourself with the unit prior to using it for the first
time. Adhere to the safety information for the correct and safe use of the unit.
Intended use
The FIAP UV Active 15 W, 35 W, 65 W and 130 W series, in the following termed unit, is a UVC
clarifying unit for cleaning normal pond water at a water temperature of + 4 to + 35 °C. The unit is
exclusively intended for private use and may only be employed for cleaning garden ponds with or
without fish population.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and
in the case of misuse. If used for purposes other than that intended, our warranty and operating permit
will become null and void.
CE Manufacturer's Declaration
We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low
voltage directive (73/23/EEC). The following harmonised standards apply:
EN 50366, EN 55015, EN 60335-1, EN 61000-3-2, EN 61000-3-3, EN 61547
Safety information
For safety reasons, children and young persons under 16 years of age as well as persons who
cannot recognize possible danger or who are not familiar with these operating instructions, are
not permitted to use the unit!
Please keep these operating instructions in a safe place! Also hand over the operating instructions
when passing the unit on to a new owner. Ensure that all work with this unit is only carried out in
accordance with these instructions.
The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly
connected or misused. Do not operate the unit if persons are in the water! Always disconnect the
power plugs from all units in the water and from this unit prior to reaching into the water and starting
work on the unit! Compare the electrical values of the power supply with those on the type plate on the
packaging or on the unit itself. Only operate the unit when plugged into an earthed socket. The latter
must have been installed in accordance with the valid national regulations. Ensure that the protective
earth wire is led to the unit. Only use electrical equipment, adapters, extension or connection cables
with an earthed contact which are approved for outside use. The cross section of power connection
cables must not be smaller than the rubber cables identified with H05-RNF. Extension cables must
meet DIN VDE 0620. Ensure that the unit is fused for a rated residual current of max. 30 mA via a
residual current-operating system (FI or RCD resp.). Keep the power plug and all connection points
dry! Protect the connection cable when burying to avoid damage. Electrical installations at garden
ponds must meet the international and national regulations valid for installers. Do not carry or pull the
unit by the connection cable! Never operate the unit if the cable or housing are defective! Dispose of
the entire unit if the cable is damaged, as the latter cannot be replaced individually. Never open the
unit or its component parts, unless this is explicitly mentioned in the operating instructions. Never carry
out technical changes to the unit. Only use spare parts meeting the quoted specifications and original
accessories. For your own safety, consult a qualified electrician if you have questions or encounter
problems!
Technische Änderungen vorbehalten. Für Druckfehler übernehmen wir keine Haftung. WEEE-Reg. Nr.: DE78152045
FIAP GmbH, Jakob Oswald Str. 16, 92289 Ursensollen
Tel: 09628 9213 0; Fax: 09628 9213 30; www.fiap.com
6
loading