Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with
the unit. Before having the unit serviced, refer to the troubleshooting chart below.
Symptom
The compact disc or tape
does not play when
p y
inserted into the unit.
No power.
The unit does not work
p p
properly (Eject, Load,
y ( j
,
,
Play).
)
The sound from the CD
player skips.
p y
p
No radio reception.
The radio does not stop on
any stations when
automatic tuning is used.
Cause
The volume control is
turned down.
The power connections are
not wired correctly.
The vehicle ignition is
switched off.
The fuse is blown.
The microcomputer has
been affected by electrical
y
noise.
The road surface is rough.
The unit is not mounted
securely.
The disc is defective.
The disc is dirty.
The antenna cable is not
connected.
The signals are weak.
- 21 -
Solution
Turn up the volume control.
Check the +12V and ground
connections.
Switch the ignition to the ON" or
ACC" position.
Replace the fuse with another
15A fuse.
Eject the disc or tape, then insert
it again.
Turn the power off and then on
again.
Wait for the road surface to
improve before playing a disc.
Install the unit securely. Be sure to
use the rear strap if the vehicle
does not provide support for the
rear of the unit. (See page 24)
Try another disc.
If it plays properly, the first disc
may be defective.
Clean the disc as explained on
pages 3-4.
Insert the antenna cable firmly
into the antenna jack on the unit.
Select a station using manual
tuning.
Capítulos
Tabla de contenido
