Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
2
3
10mm
10mm
4
014898
When the fence is set at 90°, both the distance from the
center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
bottom of the blade cover are 10 mm (0.4").
NOTE:
Remove the angle guide according to the need of your
•
work when using the tool with the angle of the fence
adjusted to other than 0 ﾟ. When you need to use the
angle guide under the above condition, be sure to
adjust the depth of groove to get a proper depth.
Set plate
2
5:
3
4mm
4
10mm
10mm
6
6mm
012258
1
014899
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
Switch action
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the slide switch actuates
properly and returns to the "OFF" position when
the rear of the slide switch is depressed.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
5
1. Lock lever
1
2. Pointer
3. Angle scale
4. Set plate
5. Thickness of set
plate
6. Center of blade
thickness
7
7. Blade cover
1. Set plate
1
014908
To start the tool, slide the slide switch toward the "I
(ON)" position. For continuous operation, press the front
of the slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing the blade
7
1
4
6
5
014909
CAUTION:
When installing the plate joiner blade, mount the
•
inner flange with the side marked "22" facing
toward you.
To remove the blade, loosen the clamp screw and open
the blade cover. Push the shaft lock and loosen the lock
nut using the lock nut wrench. To install the blade, first
mount the inner flange.
Then mount the blade and the lock nut. Securely tighten
the lock nut using the lock nut wrench. Close the blade
cover and tighten the clamp screw to secure the blade
cover.
CAUTION:
Use only Makita lock nut wrench provided to
•
remove or install the blade.
Always check the depth of groove after replacing
•
the blade. Readjust it if necessary.
7
1. Slide switch
1. Lock nut
8
2
2. Plate joiner
3
blade
3. Blade cover
4. Inner flange
5. Clamp screw
6. Shaft lock
7. Loosen
8. Tighten
Tabla de contenido
