Setting The Alarm; Factory Reset - Denver IR-110 Guia De Inicio Rapido

Setting the Alarm

1. Press the ALARM button on the remote control, the display shows "Alarm (1 or 2): Off [hh:mm]".
2. Press the / buttons to select the Alarm number (1 or 2) and then press the SELECT button to start the
setting of the following parameters.
For the following setting, press the / buttons to select then press the SELECT button to confirm.
Enable
Time
Mode
Preset
Volume
Save
Finally, select "Save" and press the SELECT button to save the alarm setting. When the alarm is set, the alarm icon
will appear on the display during standby mode.
To turn off the alarm when it sounds, press the STANDBY
During Standby mode, press the ALARM button repeatedly to turn the saved Alarm on/off.

Factory Reset

There may be times when you need to reset your unit back to the factory settings especially when you have moved
house. If you experience reception problems you may want to reset and try again.
If you move to another part of the country and pick up the local and national DAB+ stations in that area, your
previously tuned channels may no longer be available.
1. During System settings mode, press the / buttons to select "Factory reset", and press the SELECT button to
confirm.
2. Press the / buttons to select Yes, and press the SELECT button to confirm or select No to cancel.
After the system reset, all the tuned stations, DAB & FM preset stations will be erased.
Off/ Daily/ Once/ Weekends/ Weekdays
(Alarm On time)
Buzzer/ Internet radio/ DAB/ FM
Last Listened/ (Preset station)
Muted, 1-31
Save and confirm the alarm setting
or ALARM button.
ENGLISH