Produktgruppe 19
13 von 24
en
Parts required
Quantity
Mat. no.
09256130
09256140
Fitting instructions
Warning!
Heat-pump dryers must only be transported as shown, Fig. 2. If the dryer is transported in any other way, it must be allowed to stand
upright for 1 h before it is connected to the mains power supply. Otherwise the heat pump can be damaged.
A Unscrew and adjust the dryer feet as shown, Fig. 3.
A Washing machine with slanted fascia: Snap off the two plates and insert them in the frame as shown, Fig. 4, Pos. A, Pos. B.
A Washing machine with straight fascia: Snap off the three plates and insert them in the frame as shown,
Fig. 5, Pos. A , Pos. B, Pos. C.
A Washing machine with bowed fascia: Leave all three plates in position, Fig. 6
A
Stick on the sealing rings, Fig. 7.
A Turn the frame over and place it centrally on the washing machine, Fig. 8.
A Washing machine with slanted fascia: Slide the frame to the front until the inserted plates abut against the inner lid edge, Fig. 9.
A Washing machine with straight fascia: Slide the frame to the front until the inserted plates abut against the inner lid edge, Fig. 10.
A Washing machine with bowed fascia: Slide the frame to the front until the support ribs abut against the inner lid edge, Fig. 11.
A Carefully screw the frame by hand onto the washing machine lid. Take care to not overtighten the screws, Fig. 12.
A
Fit the dryer on the frame and slide its feet into the holders, Fig. 13 and Fig. 14.
A
Fit the retaining pieces and secure them, Fig. 15.
A
Fit the fascia cover piece and clip it in place, Fig. 16.
21.11.2018
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Washer-dryer stacking kit WTV 501 for tumble dryers with straight and slanted
fascia, Fig. 1
Washer-dryer stacking kit WTV 502 for tumble dryers with bowed fascia, Fig. 1
M.-Nr. 09351981
