Installation; Before The Installation - Extel WEVPMH 001 Instrucciones De Uso

4

INSTALLATION

Before the installation

IMPORTANT
IMPORTANT
1. Remove the panel of the surface-mounted housing. To do so, remove the cover (1) the screw (2) and the shim (3)
2. Lift the panel (4) and remove it.
the power supply unit (2 cables)
5. Connect the cables to the roadside panel
6. Check the orientation of the lens (readjust as shown below, if necessary)
7. Fix the cover back (8) and replace the panel in the surface-mounted housing.
8. Fix the shim back (3) with the screw (2), replace the screw cover (1)
To optimise the protection of your roadside panel, do not expose the camera to direct sun light
or a reflecting surface.
5
10
Setting the lens (fig 6)
If necessary, it is possible to adjust the orientation of the
camera (only a few degrees)
Remove the panel of the surface-mounted housing.
At the bottom of the panel, remove the screw (7) and
then the cover (8)
Then you access the orientation button (9)
Once adjusted, replace the panel.
If you try your product before installing it, make sure not to do it with the
roadside panel and the monitors in the same room, otherwise the video door
phone will produce a shrill sound (Larsen effect).
Put a silicon gasket on the upper half part between the surface-mounted
housing and the wall. The lower part must be aerated to avoid condensation
and premature oxidation of electronic products (fig 4(10)).
3
2
4
6
Fig 4
CFI EXTEL WEVPMH 001 - 03/2010 - V1
1
Fig 5
Fig 6
5GB