Charging The Battery; Operating Procedure - Carson Reflex Wheel ultimate touch 2.0 Manual De Instrucciones

CHARGING THE BATTERY

1. Insert the TX battery in the compartment on the underside of
the remote control and close the compartment again with the
closure cover.
2. Connect the USB charger lead supplied to a USB 230V adapter.
Warning!!!
Please always check before using your RC system that the RX and TX batteries are fully charged; otherwise you may lose control of your
model. Use only an appropriate charger for charging the batteries, as otherwise the battery may overheat, ignite or explode. Separate the
charger lead from the transmitter once the battery is fully charged. If you do not intend to operate your RC system any longer, remove the
TX battery before storing.

OPERATING PROCEDURE

Many publications say that the setup sequence for the transmitter
and receiver don't play a role anymore with 2.4 GHz sets. However,
we recommend sticking to the sequence typical for previous sets.
• Before operation: Connect the drive battery to the control unit.
First turn on the transmitter, then the receiver.
3. The mini USB connecter must now be connected to the USB
port, which is located on the back of the transmitter.
4. Next insert the USB 230V adapter into the socket. Charging will
now start. Alternatively, you can also connect the USB charger
lead to a computer.
• After operation: Disconnect the battery from the control unit.
Turn the receiver off, and then the transmitter.
• Before and after operating the transmitter, make sure that trim
is in the desired place and that all checks have been made.
Connection to the PC or to a USB
socket adapter
43 // GB